Xmas is a comin

 Not an awful lot to share as unfortunately the good lady wife has had a knee replacement so progress has slowed, so here are a few picks to finish the year off.

Ive got one of these to reproduce for the heat exchanger, this part connects to the rear of the heat duct that runs down the centre of the chassis and from this a pipe goes over the axle pivot tube.

Bought a couple of new toys or so  for the new year, bead roller to put ribs and steps in panels rather than forming them by hand, hopefully will speed things up, a replacement shrinker/stretcher that will allow me to replace my worn one and a set of rolls so I can finally build a wheeling machine and finally accumulated enough info to make a pullmax style power hammer, got to be good.

Many thanks for those who have viewed the blog and Ill be inviting comments from anyone viewing so hopefully I can learn more as I go along, have a good Xmas